01-13-2019, 07:27 PM
We have a new Comfort CPU 9000 - I note the following updates:
- The 8 outputs are removed from the main pcb and are on a daughter board. Would it not have made more sense to utilise an \'output\' UCM in this way it may have been possible to remotely connect or mount the utput board !
- EOL jumpers are now revoved and appear to work well in software. YES WORKS WELL.
- Tamper is now a three pin fixed to pcb - this is helpful for joining commons BUT its a different type of connector that sticks out of the side of the pcb - will this not cause problems in packaging !
- X10 removed - yep about time its totally redundent you cannot buy the X10 DIN modules now even Insteon replacements are not available.
Is there anything else we should know about!
- The 8 outputs are removed from the main pcb and are on a daughter board. Would it not have made more sense to utilise an \'output\' UCM in this way it may have been possible to remotely connect or mount the utput board !
- EOL jumpers are now revoved and appear to work well in software. YES WORKS WELL.
- Tamper is now a three pin fixed to pcb - this is helpful for joining commons BUT its a different type of connector that sticks out of the side of the pcb - will this not cause problems in packaging !
- X10 removed - yep about time its totally redundent you cannot buy the X10 DIN modules now even Insteon replacements are not available.
Is there anything else we should know about!
