Login

**wexfordman** · 01-02-2007, 11:41 PM

Hi,

I am trying to set comfort up to announce a spoken phrase on receipt of an x10 command. For example

Receive A12 ON command and announce \"water heating on\"

I did the obvious, set up a response to announce \"water heating on\" on keypad and then set up this reponse to activate based on x10 A12 On, but it does not seem to be working.

I know x10 received codes are working as I have an autoarm command based on x10 receive a3on and this works.

Regards,

Eamon

01-03-2007, 12:08 AM

What is your Comfort firmware version?
Are you trying to use the \"Announce Words\" action? If so, this may not work for earlier Comfort versions.

**wexfordman** · 01-03-2007, 12:28 AM

Main boards says 4.8.9 and UCM is 4.107. Are these the firmware versions ?

Sorry, I installed it almost 5 years ago, and have just started playing around with some of the more advanced features, so a bit rusty.

Regards,

Eamon

01-03-2007, 12:38 AM

The mainboard must be 4.223 or above for the \"announce words\" to work. Hence, that would probably explain the problem.

**wexfordman** · 01-03-2007, 12:43 AM

Cheers, that explains it.

What is the process/cost of upgrading ?

Regards,

Eamon