+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: Questions on Using Comfort (https://www.comfortforums.com/forum-159.html)
+--- Thread: Keypad Announcement based on X10 RECEIVED command (/thread-406.html)
- wexfordman - 01-02-2007
Hi,
I am trying to set comfort up to announce a spoken phrase on receipt of an x10 command. For example
Receive A12 ON command and announce \"water heating on\"
I did the obvious, set up a response to announce \"water heating on\" on keypad and then set up this reponse to activate based on x10 A12 On, but it does not seem to be working.
I know x10 received codes are working as I have an autoarm command based on x10 receive a3on and this works.
Regards,
Eamon
- Guest - 01-03-2007
What is your Comfort firmware version?
Are you trying to use the \"Announce Words\" action? If so, this may not work for earlier Comfort versions.
- wexfordman - 01-03-2007
Main boards says 4.8.9 and UCM is 4.107. Are these the firmware versions ?
Sorry, I installed it almost 5 years ago, and have just started playing around with some of the more advanced features, so a bit rusty.
Regards,
Eamon
- Guest - 01-03-2007
The mainboard must be 4.223 or above for the \"announce words\" to work. Hence, that would probably explain the problem.
- wexfordman - 01-03-2007
Cheers, that explains it.
What is the process/cost of upgrading ?
Regards,
Eamon