06-16-2011, 03:00 PM
I just saw this in the RS232 Manual, I am a bit confused about the following:
As far as I can tell the BP command is a BEEP function being returned from the UCM. With that said, what are the proper timings (in seconds or milliseconds) for the following BP commands:
BP02
BP03
BP04
Is there also a command to check the current state of Keypad beeps or should we just set it either On or Off when desired? I actually think these two commands are not implemented yet.
Thanks,
Ingo
Quote:Zone Bypass
The user may want to bypass zones for conveniemce or because it is faulty. This is done by the DA4Bzz command (Do Action 75). When a zone is bypassed, the system reports BPzz. The B?zz Query returns the bypass state of the zone. It is useful to keep track of the zones which are bypassed in a security system.
As far as I can tell the BP command is a BEEP function being returned from the UCM. With that said, what are the proper timings (in seconds or milliseconds) for the following BP commands:
BP02
BP03
BP04
Is there also a command to check the current state of Keypad beeps or should we just set it either On or Off when desired? I actually think these two commands are not implemented yet.
Thanks,
Ingo
