+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: UCMs (https://www.comfortforums.com/forum-146.html)
+---- Forum: Ethernet UCM/ETH03 (https://www.comfortforums.com/forum-113.html)
+---- Forum: UCM/ETH01 & UCM/ETH02 (https://www.comfortforums.com/forum-119.html)
+----- Thread: Ucm/Ethernet (/thread-761.html)
Pages:
1
2
- dcrera - 08-15-2007
Hi,
I am pulling my hair trying to resolve this problem.
I have a UCM/Ethernet 5.92 [font=\"Verdana\"][size=\"1\"]
SW8-F (Ethernet) shunted
SW8-H Shunted
DS Manage V5.03 cannot find the Device server.
I powered down the UCm, reset Comfort and still no joy.
I am getting two blinks on D103 (Connection Closed).
All this worked a few days ago.
I need help, maybe lots.
thanks[/size][/font]
- slychiu - 08-16-2007
Could there be a problem with your network if it worked before?
are you able to ping the UCM/Ethernet
- dcrera - 08-17-2007
Hi
Yes it can be pinged.
I tried via a router and a direct connection.
Thanks
- slychiu - 08-17-2007
Check out the support pages of the ethernet device manufacturer
eg http://wiki.tibbo.net/doku.php/find_behind_gateway
and
http://wiki.tibbo.net/doku.php
This may offer some clues to your situation
- dcrera - 08-17-2007
Will Do
- juwi_uk - 08-17-2007
Do you have a software firewall on your PC that could be blocking the traffic. I had similar problems and to prove it I temporarily disabled it to prove I could esatablish a connection. Once this was proven I then made sure the port was open in the firewall config.
Just a thought.
- dcrera - 08-20-2007
Hi,
I found some software on the net that does a port scan.
I did not find ports 1001 or 65535.
I went to my firewall settings and added these ports for DS Manager. I then reran the the port scanner software and I still don\'t see these ports.
Every other device is discoverable on my network expect my UCM/Ethernet
Thanks
- juwi_uk - 08-20-2007
Hi
Can you disable the firewall for 30 seconds and see if this works. If so at least you know 100% that it is the firewall blocking the traffic or you can move on to look elsewhere.
J
- dcrera - 08-20-2007
Hi
I turned my firewall off.
Did an autodiscovery on DS Manager.
Nothing, no Device Servers where found
Thanks
- dcrera - 08-22-2007
Hi,
How to I reset the Ucm to \'factory\' settings ?
Thanks