| Problems & Troubleshooting > evaluation kit problem (4 replies - 18038 views)
Do you mean the 12 Volt removable terminal block on the UCM was reversed?
This should not damage the UCM as it is protected against this.
Or ... Saturday Aug 4th, 2007 06:47 am Questions on Installation and Connection > Comfort phone line to PABX system (5 replies - 12697 views)
I still cannot understand what you have connected
is it TEL LINE -> Comfort TEL IN Comfort TEL OUT -> PABX
or
TEL LINE -> PABX Analog ... Saturday Aug 4th, 2007 03:33 am Problems & Troubleshooting > UCM address allocations (2 replies - 5851 views)
When you have 2 UCMs sharing the same ID, they both will respond to the poll by Comfort. In most cases when nothing is happening, ... Friday Aug 3rd, 2007 03:39 pm UCM > Rs232 Comms (35 replies - 50351 views)
The y? command should report all the installed RIO outputs
can you send your file so we can check if the Responses are out of sync?
... Friday Aug 3rd, 2007 02:38 pm Lighting Interfaces > Comfort to Dynalite problems (3 replies - 11789 views)
The Comfort Bus Monitor only works from the serial port at the moment
if you can trigger the Dynalite command from Comfigurator it means that the ... Friday Aug 3rd, 2007 02:32 pm Questions on Installation and Connection > Comfort phone line to PABX system (5 replies - 12697 views)
The connection for PABX is described in the Installation Manual which can be downloaded from www.cytech-technology.com/manuals.html
The Incoming Telephone line should go to TEL IN and ... Friday Aug 3rd, 2007 02:22 pm | 
