U/UCM no life from the ETH port - UCM Problems - Products - Comfort Automation/ Security System Forums

Home

Not logged in - Login | Register

Comfort Automation/ Security System Forums > Products > UCM > UCM Problems > U/UCM no life from the ETH port

U/UCM no life from the ETH port

Moderated by: admin

New Topic

Printer Friendly

Rate Topic

Author	Post

Posted: Sunday Dec 15th, 2024 08:48 pm

Quote

1^st Post

palmlodge
Member

Joined:	Thursday Dec 14th, 2006
Location:	United Kingdom
Posts:	510
Status:	Offline

I have had this unit for some time and has had no use of late. I want to start using this as the connectivity for the Home Assistant MQTT bridge, but found the ETH port has no life and no link on the switch. The UCM itself appears OK. Honestly, I can't recall what I last used it for.
Is there anything wrong with the DIP setup here? Any tips to pop it back to life? It's running 7.117, just updated it from an older release.
Thanks

Attachment: IMG_2213.jpeg (Downloaded 4 times)

Last edited on Sunday Dec 15th, 2024 08:49 pm by palmlodge

Posted: Monday Dec 16th, 2024 12:45 am

Quote

2^nd Post

slychiu
Administrator

Joined:	Saturday Apr 29th, 2006
Location:	Singapore
Posts:	5727
Status:	Offline

You can see it in Comfort server manager?

Posted: Monday Dec 16th, 2024 08:01 am

Quote

3^rd Post

palmlodge
Member

Joined:	Thursday Dec 14th, 2006
Location:	United Kingdom
Posts:	510
Status:	Offline

I can see it in Comfigurator and I've updated the firmware OK. There's no link light and DS Manager can't find it (because there's no link)

Posted: Monday Dec 16th, 2024 08:52 am

Quote

4^th Post

slychiu
Administrator

Joined:	Saturday Apr 29th, 2006
Location:	Singapore
Posts:	5727
Status:	Offline

If you use DS Manager it is for ETH02. CS Manager is for ETH03. ET0-3 should be 20 years old so yu should replace with eth03.
ETH02 may not be compatible with many new features

Posted: Monday Dec 16th, 2024 09:52 am

Quote

5^th Post

palmlodge
Member

Joined:	Thursday Dec 14th, 2006
Location:	United Kingdom
Posts:	510
Status:	Offline

I only need it for the MQTT IF. Do the settings look OK on the board? No reason why it shouldn't work, it has previously.

Posted: Monday Dec 16th, 2024 10:32 am

Quote

6^th Post

slychiu
Administrator

Joined:	Saturday Apr 29th, 2006
Location:	Singapore
Posts:	5727
Status:	Offline

is thegreen RDY led stead on th UCM base board? are the D9 red and D10 green leds blibkin on the base indicating the the UCM is communicating with ComfortIf everythng is OK on the UCM then ETH02 should be faulty, Electronic components have a failure rate which incraeses with time. ETH02 also runs hot which is not that good. I suspect the ETH-2 has failed

Current time is 03:00 am

Comfort Automation/ Security System Forums > Products > UCM > UCM Problems > U/UCM no life from the ETH port

Top