Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Comfort 2 Ultra and KP01 Keypad |
Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > Comfort 2 Ultra and KP01 Keypad |
| Moderated by: admin | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
AndreSz SCAMMER!!!!!
|
I am upgrading my old Comfort 1 system to Comfort 2 Ultra, but I am having problems with my existing KP01 keypad - Audio from the Keypad is distorted. The comfort 1 had a pot to adjust the audio level, but the Comfort 2 does not. - So is the KP01 basically not compatible ? - do I need a KP03 ? |
|||||||||
|
Home Comfort Installers
|
Best to fit a new keypad If you are brave and have time to spare then you might like to adjust various parameters listed under Comfiguraton settings - tuning parameters There is an explanation in the engineer set up guide..... |
|||||||||
|
slychiu Administrator 
|
KP01a dn KP03 are obsolete. The new models are KP04A, KP05A, KP06A. See the photos here http://www.cytech.biz/keypads.html |
|||||||||
|
AndreSz SCAMMER!!!!!
|
In a related question is the "Comfort Ultra II Slave Expansion Panel Plug-in Flash Upgrade [MPU01-SEM]" compatible with the SEM02 slave expansion panel. The 4.95 firmware on my slave expansion panel is not talking to the comfort II ultra or the UCM/ETH03, So I assume it needs the Flash upgrade. |
|||||||||
|
slychiu Administrator
|
The firmware 4.95 in the Slave is not firmware flashable. It cannot be upgraded. You will have to replace it |
|||||||||
|
AndreSz SCAMMER!!!!!
|
So can I use a "Comfort Ultra II Slave Expansion Panel Plug-in Flash Upgrade [MPU01-SEM]" to upgrade the firmware on a SEM02 slave expansion board. |
|||||||||
|
slychiu Administrator
|
The slave 4.95 does not have a plug-in flash upgrade Slave with firmware 5.XXX have sockets for plug in FlashThe only option is to replace with a new one. That model is about 20 years old |
|||||||||