Comfort Automation/ Security System Forums > Products > UCM > UCM Problems > ETH02 Connection Timeout setting |
Comfort Automation/ Security System Forums > Products > UCM > UCM Problems > ETH02 Connection Timeout setting |
| Moderated by: admin | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
gaynorc Member
|
On the ETH02 I purchased this august, the "connection timeout (min)" entry in DS Manager was set to 5 minutes. In the UCM manual downloaded from Cytech the diagram shows the "connection timeout (min)" set to "0=Disabled". Which setting do you advise for use with ETH02? Thanks |
|||||||||
|
ident Administrator 
|
This should be set to 1 minute especially if used for iPhone It disconnects if there is no communications for the idle time so it avoids a device hogging the connection Only 1 connection at a time is allowed to the UCM/Ethernet It is also good for security so that someone cannot pick up the phone or computer and control your system The new firmware/application for the ETH02 should also be used |
|||||||||