View single post by darnold | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Saturday Jul 6th, 2024 12:22 pm |
|
||||||||||||
darnold
![]() |
Well I thought I had it cracked but I am not so sure. It is certainly possible that both DM02s are bad. I know one of the modules is defective. I thought the other was okay but not sure. Let me see what you think. My configuration is as follows: Comfort ULT running the latest firmware v7.213. For testing purposes, I have 2 UCMs (an Ethernet UCM and Dynalite Gateway UCM). I have just one of the DM02 connected and I have a KP04 connected as well. I have 16 Zones connected to the system. Let me describe exactly what happens when I power on the system (without the battery connected): -KP04 Display Reads: ID#1 Ver1.08e -After about 15 seconds a series of rapid beeps are heard lasting 7 seconds from the KP04 speaker -KP04 announces "Security Off" -KP04 Displays the date and time and "Security Off" Pressing the SW2 on the DM02 causes the phones to ring in the home and the KP04 announces "Front Door". The UCM Monitor shows the following: < DB31 < SM000140 < SM000140 < SM000000 < SM000000 < SM000000 < SM000000 < DBFF At this point everything seems fine. I have very simple scripts for opening and closing a gate located on the property. For example to open the gate the response is: If Input Gate = 0 Then Open Door 1 1 10 End If If I then run the GateOpen response either through the Home Control menu on the KP04 or via Comfort Configurator the following occurs: -After about 15 seconds a series of rapid beeps is heard from the KP04 speaker followed by a flashing message saying "Communication Failure Keypad 1." (It appears that the system has reset itself). -KP04 then announces security off and displays the normal date&time and alarm status. -The relay on the DM02 does not fire (the gate remains closed). The UCM Monitor shows the following: > DA4F107304C831010AFF < Cs01 < Cs02 > DA4F107304C831010AFF > DA4F107304C831010AFF < Cs01 Occasionally, if I execute the GateOpen response it will repeatedly flash the message "Communication Failure Keypad 1" and the phones will ring and the warble tone is heard. Very often I am forced to cut the power to the system in order to stop this. As I said at the beginning, I suppose both DM02s could be bad but I thought I would check with you first. Thanks for the help!
|
||||||||||||
|