View single post by Majik
 Posted: Friday May 19th, 2023 10:10 am
 Full Topic 
Majik

 

Joined: Saturday Aug 26th, 2006
Location:  
Posts: 33
Status: 
Offline

  back to top

Unfortunately, I didn't have much time to look at this before I had to travel.
I had already ordered a replacement board from Laser, as well as the UCM/USB.
I ended up replacing the CPU board and leaving the DSP board, simply for speed and convenience, and reloading the config across the network, so it is back and running.
However, I did initially try programming the new CPU board from the UCM/USB using the programming cable, and that failed in the same way, with the continuous reboot.
So this indicates some other issue with the system which I haven't tracked down: I suspect either the DSP board or, maybe, a power problem (although I have the new enclosure with 2A supply, and I'm not running that many things on it).
Either way, it currently works.
I was planning to bring the original CPU board back to Singapore with me but, in my rush, I forgot to pack it.
Cheers,
Keith

 Close Window