No Sound on PC with WizComfort!

[namnp]

I can arm/ disarm with WizComfort/Keypad and voice on external power speaker is OK (via Line Out 3mm jack). Just there is no sound on built-in PC/ Speaker & Mic (via Out+GND UCX PCB\' terminal to Mic input of PC);


UCX 5.92 (with Audio); Comfort firmware 5.45; WizComfort version 1.4.6.

What shall I need to check?

Thanks

Even I can see the command from Comfort to PC as SM000040, SM000140, SM000000 after the command ... as below within Comfort monitor
 

I?0101

PS00

SM000040

SM000140

MD025A

AM095A

KL01000000

AL130000BF025A

KL01000000

SM000000

 

[adlim]

Could you have forgotten to enable the microphone settings on your PC\'s volume control? Does a normal microphone work correctly when it is plugged into the PC\'s mic input?

[namnp]

System sound now finally via UCX, even not as loud and clear as I expected with keypad ! It may need to improve connecting wires externally, I suppose and would do it to see how much better sound can get.

(And also better result when using UCX\' Voice out 3.5mm jack with external power speaker - not the Line OUT terminal to notebook\' Mic input!)

Thanks