WizComfort 1.9.2 Beta

[slychiu]

Wizcomfort 1.9.2 Beta can be downloaded from here

Recommended Minimum Firmware Requirements
Comfort 5.199
UCM 5.216
Older versions may lack features or not perform fully


New Features

1. Trouble Conditions and parameter eg ID are shown
2. Greeting Messages, alarm message, user names, Reminder Messages  can be  recorded and heard (AUD01 module is required)
3. Outputs in Comfort and RIO cannot be changed due to possibility of damaging any connected device
4. Trouble state can be displayed for each zone, besides On and Offf
5. In Security Page, Entry/Exit Time countdown is shown during Arming and Disarming. Countdown stops when system is armed or disarmed or alarm occurs.
   
6. Zone Not Ready number is shown in Security Page while arming
7. When Wizcomfort logs in, it requests the state of used Counters and sensors only instead of all counters and Sensors
8. WizComfort queries for all flags. However if the UCM handles the new f?00 command to query for all flags (UCM 5.216) then a single command can retrieve all flag states.
   
9. Setting \"Audio on Keypad\" selects whether the keypad sign in will go to the user menu or without menu (ie whether the # key sends the # or ENTER value)
10. Identification > User. Added Delet User Button
11. Users can record their own names for their mailbox.
12. Intercom to Door Station and Keypad is now working
13. In the Security Page, the Away, Night and Day Icons show the current security mode
    

[juwi_uk]

Chiu,

Looks good.

One question.  There\'s a lock item in the bottom status bar.  I\'m presuming it locks the UI?  How do I activate the lock?

Regards

Julian

[slychiu]

The lock icon shows that the system is  armed. Unlock means it is disarmed
It does not mean the UI is \"locked:

The Feature list has now been added in the above post