Firmware 8.001 to 8.031

[slychiu]

Version 8.018
Bugs

1. SN01 from eth0 plug in gave wrong value, but from ucm is correct
2. b?00 bypass request bits from ETH03 plug in s correct but from ucm is wrong
3. In test mode failed AC power off detection bug from 19/1/25
4. virtual input on zones 1 to 16 did not work
5. For ARM only, virtual inputs do not work correctly. When they are activated, they will reset to the state of the physical input
6. \"enter new code and # key\" is announced  for change/add user code on keypad after entering new code 2 times, but new code is actually accepted. bug for Toshiba only not ARM

Changes

1. Fixed BUG from 20/1/25 IRIO comms trouble did not detect

Version 8.020 Bugs

1.  SN01 from eth0 plug in gave wrong value, but from ucm is correct
2. b?00 bypass request bits from ETH03 plug in s correct but from ucm is wrong
3. In test mode failed AC power off detection bug from 19/1/25
4. virtual input on zones 1 to 16 did not work bug
5. For ARM only, virtual inputs do not work correctly. When they are activated, they will reset to the state of the physical input
6. \"enter new code and # key\" is anounced  for change/add user code on keypad after entering new code 2 times, but new code is actually accepted. bug for Toshiba only not ARM

Changes

• y?00 request_fixed BUG caused reset
• TExx test eeprom enhanced command xx = 01 for 1st eeprom, 02 for 2nd eeprom if no xx then xx=1 eg TE01, TE02,.
• Fixed some bugs in KNX/Logic
• Improved Battery disconnect test for ARM. When battery is not connected,  F31 detects low bat consistently  and immediately now. Before it sometimes did not detect low battery and was always delayed by 10 seconds.
  
• u?84 and SN84 causes firmware to reset due to overwrite of caused IRIO not to have rs485 comms trouble when disconnected
• When DC input is switched off during Battery test D? does not show very low DCVOLTAGE
• Prevent Battery disconnnect test during firmware upgrade
• If battery is low or disconnected Firmware upgrade will cause UBF7 error