Firmware 8.001 to 8.031

[slychiu]

Version 8.015

Bugs

1. Battery check F3,1 when battery disconnected is delayed by 10 seconds and some times does not work from 7.22
2. Battery disconnected does not work when there is no battery
3. u?82 and higher causes system reset for ULTRA
4.  IRIO01 lost comms does not report, restore does not report
5. SN01 from eth0 plug in gave wrong value, but from ucm is correct
6. b?00 bypass request bits from ETH03 plug in s correct but from ucm is wrong
7. Home control menu announces press # to end only for ARM firmware
8. GSM dial to CMS sometimes times out waiting for kissoff from CMS
9. For ARM only, virtual inputs do not work correctly. When they are activated, they will reset to the state of the physical input
10. \"enter new code and # key\" is anounced  for change/add user code on keypad after entering new code 2 times, but new code is actually accepted. bug for Toshiba only not ARM

New Feaures

• For Ultra Firmware the 1st 32 Counters 0 to 31 and All 256 flags are saved in EEPROM,so the values are retained after reset or power off. This is already done in KNX/Logic, EMS, UCM/Logic, LGX01, But Not for Optimum firmware. [color=\"#ff0000\"]WARNING! if you upgrade to ULTRA firmware 8.013 or later  from an older version before 8.013 . initially all flags and 32 counters will be set to on (or 255 for counters). [/color][color=\"#ff0000\"] If you have flags or counters programmed to activate some function disable these functions when you upgrade the firmware.[/color]
• Fixed Bug From firmware 7.198 - If UCM/knx, UCM/CBus, UCM/Modbus has address  mapped to Flag, Comfort broadcasts the flag to all UCMs but the source ID of the UCM changing the flag is not sent correctly by Comfort. This may cause the UCM to send an extra unneccessary message back to the external Interface for KNX, CBus, Modbus etc. This does not cause the UCM not to work , it just causes an extra message to be sent back to the Interface