Bugs
- From firmware 7.198 - If UCM/knx, UCM/CBus, UCM/Modbus has address mapped to Flag, Comfort broadcasts the flag to all UCMs but the source ID of the UCM changing the flag is not sent correctly by Comfort. This may cause the UCM to send an extra unneccessary message back to the external Interface for KNX, CBus, Modbus etc. This does not cause the UCM not to work , it just causes an extra message to be sent back to the Interface
- Battery check F3,1 when battery disconnected is delayed by 10 seconds and some times does not work from 7.22
- Battery disconnected does not work when there is no battery
- u?82 and higher causes system reset for ULTRA
- For ARM only, virtual inputs do not work correctly. When they are activated, they will reset to the state of the physical input
- \"enter new code and # key\" is anounced for change/add user code on keypad after entering new code 2 times, but new code is actually accepted. bug for Toshiba only not ARM
- Fixed BUG (Not applicable to ARM)- Upgrade Sentences/ Keypad failed at Keypad LCD words stage, Keypad shows Incompatible (applies to non-ARM firmware only - ARM firmware does not have this bug)
- 32 Counters and all 256 Flags are saved in EEPROM at reset (applies to ULTRA only. EMS, LGX, UCM/LOGIC and KNX/Logic already has this feature. Optimum has not implemented this feature). [color=\"#ff0000\"]WARNING! if you upgrade to this firmware or later from an older version. initially all flags and 32 counters will be set to on (or 255 for counters)/ If you have flags or counters programmed to actvate some function disable these fnctions when you u[grade the firmware[/color]