Bugs
- From firmware 7.198 - If UCM/knx, UCM/CBus, UCM/Modbus has address mapped to Flag, Comfort broadcasts the flag to all UCMs but the source ID of the UCM changing the flag is not sent correctly by Comfort. This may cause the UCM to send an extra unneccessary message back to the external Interface for KNX, CBus, Modbus etc. This does not cause the UCM not to work , it just causes an extra message to be sent back to the Interface
- For ARM only, virtual inputs do not work correctly. When they are activated, they will reset to the state of the physical input
- \"enter new code and # key\" is anounced for change/add user code on keypad after entering new code 2 times, but new code is actually accepted. bug for Toshiba only not ARM
- Fixed Bug Sunset Time Response did not work
- If file system in comfort is wrong eg Ultra should have File System 34 but for some reason the wrong file system was loaded, then the plug in ETH03 on CM9001 could not log in. This has been fixed in 8.011
- Battery check F3,1 when battery disconnected is delayed by 10 seconds and some times does not work from 7.22
- Battery disconnected does not work when there is no battery
- u?82 and higher causes system reset for ULTRA