Firmware 8.001 to 8.031

[slychiu]

Version 8.010
Bugs

• Sunset Response pointed to the wrong EEPROM location
• Transfer > Upgrade Sentences fails at LCD keypad words (No Bug for Arm Version)
• From firmware 7.198 - If UCM/knx, UCM/CBus, UCM/Modbus has address  mapped to Flag, Comfort broadcasts the flag to all UCMs but the source ID of the UCM changing the flag is not sent correctly by Comfort. This may cause the UCM to send an extra unneccessary message back to the external Interface for KNX, CBus, Modbus etc. This does not cause the UCM not to work , it just causes an extra message to be sent back to the Interface
• Battery check F3,1 when battery disconnected is delayed by 10 seconds and some times does not work from 7.22
• Battery disconnected does not work when there is no battery
• u?82 and higher causes system reset for ULTRA
• For ARM only, virtual inputs do not work correctly. When they are activated, they will reset to the state of the physical input
• \"enter new code and # key\" is anounced  for change/add user code on keypad after entering new code 2 times, but new code is actually accepted. bug for Toshiba only not ARM

Changes and New Features

• fix bug if virtual input, If another input active still has virtual input_flag set, zone trouble may occur when new zone activated  while virtual input is active  This bug existed from the time Virtual Inputs was introduced and the combination  rarely occurs
  
• Fixed other bugs in version 8
• Dial to CMS - If no kissoff is received, only 1 attempt without redial instead of 3 attempts. However Comfort will redial the CMS after each dial cycle. This change reduces the time taken to dial to CMS if a kissoff is not received - as immediate redial always fails