Firmware 8.001 to 8.031

[slychiu]

Version 8.003
Bugs      

1. Action 200 open door Response caused reset
2. zone announce on zone off says Zone Trouble
3. BUG from 7.230  alarm type dial index always announce 0,0,0,0, on keypad
4. Sunset Response pointed to the wrong EEPROM location. m,ay cause unexpected results due to the contents of the eeprom location
5. Transfer > Upgrade Sentences fails at LCD keypad words (No Bug for Arm Version)
6. if virtual input is activated, the 1st non-virtual zone activated will cause momentary zone trouble
   
7. From firmware 7.198 - If UCM/knx, UCM/CBus, UCM/Modbus has address  mapped to Flag, Comfort broadcasts the flag to all UCMs but the source ID of the UCM changing the flag is not sent correctly by Comfort. This may cause the UCM to send an extra unneccessary message back to the external Interface for KNX, CBus, Modbus etc. This does not cause the UCM not to work , it just causes an extra message to be sent back to the Interface
8. Battery check F3,1 when battery disconnected is delayed by 10 seconds and some times does not work from 7.22
9. Battery disconnected does not work when there is no battery
10. u?82 and higher causes system reset for ULTRA
11. For ARM only, virtual inputs do not work correctly. When they are activated, they will reset to the state of the physical input
12. \"enter new code and # key\" is anounced  for change/add user code on keypad after entering new code 2 times, but new code is actually accepted. bug for Toshiba only not ARM

Changes and Bug Fixes 
Fixed bug for incorrect for Time programs,  sunrise response,  doorphone response, HVAC- BUT Sunset response was not fixed