Firmware 8.001 to 8.031

[slychiu]

Version 8.001
Bugs

1. BUG  from 17/4/24 7.230  alarm type dial index always announce 0,0,0,0 on keypad
   
2. For Ultra - EEPROM locations are incorrect for Time programs,   sunset response sunrise response,  doorphone response, HVAC
   
3. Transfer > Upgrade Sentences fails at LCD keypad words (No Bug for Arm Version)
   
4. From firmware 7.198 - If UCM/knx, UCM/CBus, UCM/Modbus has address   mapped to Flag, Comfort broadcasts the flag to all UCMs but the source  ID of the UCM changing the flag is not sent correctly by Comfort. This  may cause the UCM to send an extra unneccesary message back to the  external Interface for KNX, CBus, Modbus etc. This does not cause the  UCM not to work , it just causes an extra message to be sent back to the  Interface
   
5. Battery check F3,1 when battery disconnected is delayed by 10 seconds and some times does not work from 7.22
   
6. Battery disconnected does not work when there is no battery
   
7. u?82 and higher causes system reset for ULTRA
   
8. For ARM only, virtual inputs do not work correctly. When they are activated, they will reset to the state of the physical input
   
9. \"enter new code and # key\" is anounced  for change/add user code on keypad after entering new code 2 times, but new code is actually accepted. bug for Toshiba only not ARM
   

Changes and Bug Fixes

•  fixed BUG OPTIMUM Only  - F2 home control cause wrong announcement
  
• Fixed bug from V7.255 engineer  menu 6789 7,43, announce firmware announce was blank
  
• Fixed  bug ULTRA CMS Format  was at wrong address so cms could not dial out