+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: GSM Module (https://www.comfortforums.com/forum-48.html)
+--- Thread: alarm activation (/thread-5870.html)
alarm activation - raygregg114 - 06-03-2026
Over the last few months when the alarm is activated it will ring through to my mobile but there is no voice response.
Before you would have been told where the activation was etc.
Does anyone have the same issue.
RE: alarm activation - slychiu - 06-04-2026
Check that the 5 way audio multicolour cable is properly plugged in from GSM to Comfort.
was 3G just disabled in your country? and is your module SIM7600E whichuses 3G for Voice?
RE: alarm activation - raygregg114 - 06-04-2026
Hi, I have just contacted the mobile supplier and they say the 3G has been disabled, does this mean i need to change the GSM board and get a new simm?
RE: alarm activation - slychiu - 06-04-2026
yes you will have to get a new UCMA/4G7608 which works on 4G/LTE
If your sim card is 3G then you will need 4G/5G
alarm activation - raygregg114 - 11-04-2026
(06-04-2026, 08:55 AM)slychiu Wrote: yes you will have to get a new UCMA/4G7608 which works on 4G/LTE
If your sim card is 3G then you will need 4G/5G
Hi,
New board and simm installed but system is still not anouncing the activation zone after an activation.
Also the Siren is going off randamly, can be day of night and happens when the system is disarmed.
5 core cable is present and connected.
On;ly way to silence the siren is to hard reset the system.
Ray
RE: alarm activation - slychiu - 11-05-2026
lets continue this in this forum https://www.comfortforums.com/thread-5998-post-28417.html#pid28417