+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: KNX (EIB) (https://www.comfortforums.com/forum-12.html)
+---- Forum: KNX/Logic Firmware (https://www.comfortforums.com/forum-142.html)
+---- Thread: KNX/Logic 7.155 to 8.014 (/thread-5520.html)
- slychiu - 11-13-2024
KNX/Logic 7.155
Initial release
- slychiu - 11-13-2024
KNX 8.014
- 1st 32 Counters are saved in EEPROM so they do not change after power off or reset
- Fixed Bug - KNX Monitor mode caused write to KNX EEPROM
- Write to KNX EEPROM fixed bug which caused occasional fail to erase and hangs Comfigurator
- Improvement of function when KNX to Comfort Group Address mapped to Flag, Counter or sensor is received, and Flag to KNX, counter to KNX or Sensors to KNX for the register is mapped to another KNX adress, then the change us sent to the KNX address â this did not work. Eg if KNX0/0/1 is mapped to Comfort Flag 1, and in Flag to KNX tab, Flag 1 is mapped to another KNX Addres eg 1/1/1, then KNX 0/0/1 received by KNX/logic is also sent to KNX 1/1/1
- Arm Version released
- Released KNXA/logic for Arm Processor