+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: KNX (EIB) (https://www.comfortforums.com/forum-12.html)
+--- Thread: where to download the .knxprod file? (/thread-3752.html)
- agenor - 04-03-2014
Hello!
As trivial a question as it may seem, but - where from do we download the .knxprod file for the ETS4 KNX programming software? Without it, the ETS4 doesn\'t recognize the UCM/KNX.
Thanks!
- ident - 04-03-2014
The UCM/KNX is not like a KNX device, it is not programmmed by ETS
You program in Comfigurator by mapping the group addresses to Comfort counters, sensors, virtual inputs and other registers
The UCM/KNX manual will explain in detail. download from https://www.cytech.biz/ucmknx_manual.html?category_id=107
- agenor - 04-03-2014
OK, so this means that the unit cannot even be defined in the ETS software (so that it is known that there\'s a device with that individual address)?
Thanks!
- ident - 04-03-2014
Correct, but there is little benefit to be able to see it in KNX from what I can see