+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: Questions on Using Comfort (https://www.comfortforums.com/forum-159.html)
+--- Thread: Power outage (/thread-3395.html)
- strickers - 05-24-2013
Hi,
I have two questions.
1. How do I get an output to work only during a intruder alarm and turn off when the alarm is reset?
2. Why when the SEM01-M2 loses power does the system not warn me? The slave and main have different mains inputs. So the main will still have power but I thought it would still let me know
Thanks.
- ident - 05-25-2013
Quote:1. How do I get an output to work only during a intruder alarm and turn off when the alarm is reset?
In Alarm Types > Intruder Alarm, assign the alarm Response to turn on the output
In Alarm Types > Disarm, assign the Alarm Response to turn off the output
There is a simpler way in the beta firmware ULT 7.030
http://www.comfortforums.com/view_topic.php?id=3383&forum_id=79
Status > Outputs has Set/Unset Outputs. You just enter the output name/number
Quote:2. Why when the SEM01-M2 loses power does the system not warn me? The slave and main have different mains inputs. So the main will still have power but I thought it would still let me knowThis was done because in a power failure affecting a large number of houses, this would cause too many extra dial outs to the monitoring system so many alarm systems disable the alarm for a slave power failure. The low battery alarm for SEM will warn you