+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Products (https://www.comfortforums.com/forum-3.html)
+--- Forum: Questions on Using Comfort (https://www.comfortforums.com/forum-159.html)
+--- Thread: Delay on startup event. (/thread-2329.html)
- TheMax74 - 07-05-2011
Hi,
i\'ve a startup response that turns ON some outputs on Comfort and on two SEM\'s
After a reset, the outputs on Comfort are set to ON, but not on SEM\'s
I suspect that SEM\'s take more time to reset and to start communicating over the bus.
For now, i\'m using a TIMER to delay the change of outputs state, but i think that the startup event should fire only after all devices (UCM\'s, SEM\'s, etc.) are ready for operation.
;-)
- slychiu - 07-05-2011
Good suggestion. We will look at that