+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html)
+---- Forum: Firmware Upgrading Problems (https://www.comfortforums.com/forum-111.html)
+---- Thread: UCM Firmware upgrade when UCM has no notch? (/thread-2307.html)
- schford - 06-15-2011
Hope someone can advice,
Brian (bs85) sent me his UCM/ethernet so I could get them both upgraded to latest 6.02 release.
My upgrade went straight in (though it took me a few mins to remember how to change IP address in tibo)...
I then swapped over to do Brians and noticed that his ethernet board does not have a notch in so I cannot insert the jumper to cover then 2 pins on PP2 to put it into programming mode....
Anyone got a quick easy solution for me so I can get it back in the post to him tomorrow?
Cheers
Stuart
- Ingo - 06-15-2011
The Ethernet daughterboard can unscrew easily, remove it, insert the jumper and plug the daughterboard back in. Once done you can reverse the procedure.
Ingo
- schford - 06-15-2011
Thanks all done!