+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Comments, Suggestions & Feedback (https://www.comfortforums.com/forum-22.html)
+---- Forum: Wishlist (https://www.comfortforums.com/forum-66.html)
+---- Thread: Blinds relay (/thread-2139.html)
Pages:
1
2
- Home - 01-20-2011
Any chance of a blinds relay unit similar to the CBUS blinds and shutter relay (but on the Comfort bus)
- safety interlock
- reverse polartiy and split winding motors
- mains and low voltage
- LED indicator up down
- slychiu - 01-21-2011
Thats also a good suggestion
- Home - 02-23-2011
Do we have any progress on this topic - is it on the agenda yet?
- slychiu - 02-24-2011
Afraid we are not so fast
- Home - 08-25-2012
I don\'t suppose.......
- slychiu - 08-26-2012
That will be in the \"Intelligent\" RIO
- Home - 09-01-2012
Not my preference
If you have mains blinds then I would not want to bring the 240V blinds feeds into a main comfort enclosure.
Take another look at the CBUS blinds relay - it is well though out and accomodates both reverse polarity (usually 24Vdc) motors and split winding (usually mains) motors.
ALSO the CBUS unit has manual over ride - very important.
Tacking it onto the back end of a RIO is not what we are after.
- mikegriff - 09-02-2012
Hi
Is it such a silly suggestion
It will only need the KA/KB
All powered locally
It could control the blinds and give some cheap remote inputs to boot
I\'m sure by now it could be fitted into a small smart box
Mike
- Home - 09-03-2012
Its not s silly suggestion at all and can readily be achieved.
Here are the down sides once again
- What ever is said the RIO option will encourage the use of mains power in the same enclosure as the main CPU or UCM\'s
- In our design we always try to offer \'manual overrides.
The CBUS blinds relay is well though out and inexpensive.
- slychiu - 09-03-2012
RIO need not be in the same enclosure as Comfort, it can be separate
I dont se what is the problem with manual override
Cbus is not suitable for all installations. It is not cost effective to add just a Cbus blinds relay to a non cbus system