Comfort Automation/ Security System Forums
My new project - Printable Version

+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Comfort Around The World (https://www.comfortforums.com/forum-6.html)
+--- Forum: Comfort Case Studies and Installations (https://www.comfortforums.com/forum-54.html)
+--- Thread: My new project (/thread-2107.html)

- TheMax74 - 12-23-2010

Hello,
i\'m moving to a new home, so i need to expand my Comfort system.
The new system consist of:
  • Comfort panel Ultra II
  • 3 Keypads
  • UCM/ETH, UCM/GSM, UCM/KNX, UCM/AUD
  • 2 SEM (8 Input + 8 Output each)
  • 3 LEM (8 Input + 8 Output each)
  • 2 Enclosures for UCM\'s and SEM\'s
Let\'s go. For convenience, i put all SEM with LEM in a single enclosure, taking care to let all SEM\'s connectors and EOL jumpers accessible for settings zones and for firmware update. Here you will see only the enclosure with SEMs. The Comfort main panel is not showed.
This is a shot.














Here you see the back of enclosure,
with tamper, compared to a kindle DX.











Some KNX stuffs. This is
an INPUT/OUTPUT actuator from ABB:
the RoomMaster RM/S2.1









This is the enclosure reserverd for all UCMs.
The power supply, in this case, is not used.












This is a shot of some webcams for outdoor security. They will sends a message to the Comfort panel, trough a Gira Homeserver 3. Thanks to the new Comfort firmware, you can assign a zone to a KNX group address. Gira Homeserver receives an IP telegram from a Webcam, then sends \"ON\" to a goup address mapped to a Comfort\'s zone. It\'s not the \"top of security\", but help me in some automation features.








This is a POE 1GB/s 8 ports router,
for powering and data transmission for all webcams.










This is my new keypad, compared to a Gira keypad. The Gira keypad is used to open the front door.
Cytech will release a new keypad (very beautiful) that fits in a standard system55 box.
Unfortunately, i already have a spare \"old\" keypad.







This is the AUDIO module for the UCM01.
This will be connected to the Gira KNX multiroom system, in the priority input, to send
allarm messages to the whole house.




And this is the Gira KNX multiroom system





Thanks for watching.



- slychiu - 12-24-2010

Nice work. I hope you will  update us when the installation is completed


- TheMax74 - 05-25-2011

Wiring work is started. Near ready for a full project description.
Here you see a relay module, for internal bell boxes and comfort \"system armed\" mode annunciator.




- ident - 05-25-2011

Thanks, this topic has been moved to  the \"Comfort Case Studies and Installationbs\" Forum