Hi Yes I checked the CCL file and there are loads in there (> 1090 responses!) I started again with a blank CCL file and cut and ...   Sunday Jul 8th, 2007 10:08 am

Getting this when I open my CCL file in Comfigurator 2.2.0. Tried everything to get rid of them but to no avail. How can I get ...   Saturday Jul 7th, 2007 06:58 pm

Hi I've been using comfigurator 2.1.2 for a while now on Vista Ultimate against my Comfort Ultra II via UCM/Ethernet. I could use any user code ...   Saturday Jul 7th, 2007 01:34 pm

Hi Just to add my note,  I had no problem getting 2.2.0 or the previous 2.1.2 interim version of Comfigurator running on Vista Ultimate either.  I ...   Friday Jul 6th, 2007 08:14 am

Hi, Leaving aside for the moment the CWM module and it's (non) availability right now. Given an UCM/Ethernet card (principally used for Comfigurator access),  what is the ...   Wednesday Jul 4th, 2007 05:16 pm

Just tried the new 2.2.0 version;  looking gooood......! Only bit that doesn't seem to work is the new "Sunrise/Sunset Times".   Whilst not a big deal it ...   Sunday Jul 1st, 2007 06:45 pm

Ok. All the pictures I've seen of the card though just show the single pins sticking up at the top edge of the PCM onto which ...   Wednesday Jun 27th, 2007 06:22 pm

I finally solved my this problem this week. By process of elimination I found that my main PC in the same room as the switch was ...   Wednesday Jun 27th, 2007 06:18 pm

Thanks. Glad it's not just me finding these instructions difficult to decipher. I'll have to email Optex then and see if they can shed any light. I fear ...   Tuesday Jun 26th, 2007 08:34 pm

If I understand the specs I've read the recommendation is to site the UCM/Smartfit in a Unibox next to the Smartfit control box;  in my ...   Tuesday Jun 26th, 2007 08:31 pm

Hi, I purchased a couple of these recently and want to enable the audible alarm feature when my Comfort Ultra II panel is armed. In the attached ...   Saturday Jun 23rd, 2007 09:49 pm

Hi, I've just added two Aico Ei166 mains-powered smoke alarms to my house.  These are interconnected so when one alarms they all alarm.  I currently have ...   Tuesday Jun 19th, 2007 10:31 am

Hi, I couldn't get the one supplied on the comfort CD to work either, but then again I'm using Vista Ultimate. It would install Ok but ...   Sunday Jun 10th, 2007 05:39 pm

Hi, One thing that slightly confuses me about Comfort is that you need a UCM/Ethernet  to be able to programme Comfort over Ethernet (LAN),  and a seperate ...   Thursday Jun 7th, 2007 03:19 pm

Hi, I installed an LW10U and initially it seemed to work ok, but then stopped and refused to respond to any commands. Now it seems to be ...   Wednesday Jun 6th, 2007 08:13 pm