Hi Ident This looks good as i already have some Visonic detectors. Does the Visonic Receiver need the relay board to connect to the zones on ...   Thursday Jul 4th, 2013 04:00 pm

All working now!!! Doh - jumper setting to add eth02 board... Lots to do - now have cameras talking to comfort via TCP yippee. ...   Monday May 20th, 2013 08:57 pm

Tried changing the header to 0 but no change still not seeing anything..... ...   Monday May 20th, 2013 06:01 pm

Ok cheers, i'll try that. I'm not back until later tonight to test. I updated the firmwares at the weekend as per your information, Thanks ...   Monday May 20th, 2013 12:51 pm

last image. The only thing ive changed is the baud rate the max setting that matches is 38400 but ive tried it at others also. Thanks ...   Monday May 20th, 2013 07:14 am

3rd image ...   Monday May 20th, 2013 07:12 am

2nd image ...   Monday May 20th, 2013 07:11 am

1st image ...   Monday May 20th, 2013 07:11 am

Hi Ident I tried a few different settings and the camera is definately sending a message to the correct port on on the universal ucm, the ...   Sunday May 19th, 2013 07:38 am

Ok thanks I'll give that a whirl and try again. The Axis P8221 is my other option, I can send it a http cgi command to ...   Saturday May 18th, 2013 09:29 am

Hi Ident Thanks i now have the Universal UCM with an Eth02 piggy back. I have configured it to an IP and port 192.168.0.126 : 1020. Can you ...   Friday May 17th, 2013 02:51 pm

Hi, Yes i could but id like to try and use the network if possible My camera has different motion detection windows so i would like ...   Tuesday May 14th, 2013 08:18 pm

Hi All - I'm new to comfort and have a question which i hope someone maybe able to answer. I have a new Comfort Ultra with ...   Tuesday May 14th, 2013 02:47 pm