UCM/Pi > CM4 Compatibility? (2 replies - 2874 views)
Hi I just purchased a UCM/PI from Laser.com and I am now trying to find a Compute Module to fit it - lead time 47 ... Tuesday Feb 22nd, 2022 10:03 am Zwave > Using Virtual ZWave Nodes to interface to SmartThings hub (7 replies - 10456 views)
Hi, thanks for the information.
I think the problem is that I am using Virtual Nodes to make Comfort simulate ZWave nodes that are actually CBus ... Monday Feb 11th, 2019 03:32 pm Zwave > Using Virtual ZWave Nodes to interface to SmartThings hub (7 replies - 10456 views)
Hi, thanks for the information. I read with interest that you can map both cbus and zwave to the same counter. I have an original ... Tuesday Feb 5th, 2019 12:09 pm Zwave > Using Virtual ZWave Nodes to interface to SmartThings hub (7 replies - 10456 views)
Hi Ian,
Thanks for the heads up. I have read your post and it seems like the 'special' version of the ZWave firmware would do what ... Monday Feb 4th, 2019 12:55 pm Zwave > Using Virtual ZWave Nodes to interface to SmartThings hub (7 replies - 10456 views)
Hi All,
I'm after a bit of advice. I have a Comfort system with CBus integration. Recently I have managed to connect the Comfort to SmartThings ... Saturday Feb 2nd, 2019 07:35 pm Questions on Using Comfort > Comfort I Zone electrical characteristics (3 replies - 6782 views)
Hi Slychiu,
Thanks for your reply. I have considered using a current sensor (I already have several relays) but I wanted to keep things as simple ... Wednesday Mar 31st, 2010 05:39 am Questions on Using Comfort > Comfort I Zone electrical characteristics (3 replies - 6782 views)
Hi, I have a question about the electrical characteristics of zone inputs.
I am using an output to drive a relay which switches an AC ... Tuesday Mar 30th, 2010 06:20 pm |