Can you please describe the start-up process Comfort goes through after: 1, System power cycle (removal of AC & Battery power) 2, Reset button pushed on the main ...   Monday Nov 29th, 2010 09:16 am

Thanks, exactly what I was after. ...   Saturday Nov 20th, 2010 09:43 am

On a System Restart I wanted to query the Sunrise/Sunset Times to the current time and set a flag which would be used in other ...   Saturday Nov 20th, 2010 07:16 am

Is there any way to control the function of the keypad LED via response programming? E.g. If garage door is open flash a combination of keypad ...   Sunday Oct 31st, 2010 02:53 am

Connected extra cable from SEM02 terminal JP1 back to Comfort, this solved the voltage drop issue. Tested with manual battery test all OK Tested with automated 12:01 ...   Sunday Jul 25th, 2010 07:31 am

Can you please outline the firmware update options for the following hardwear: 1x Comfort Ultra II - v5.079 1x SEM02 - v4.177 1x UCM CBUS - v5.75 1x UCM ...   Sunday Jul 25th, 2010 07:25 am

Battery Voltage after 2min - 12.54 SEM02 Voltage after 2 min - 11.87 Connection cable 400mm long. ...   Saturday Jul 24th, 2010 06:53 am

I have done the battery check: AC Power Off - Battery Voltage 13.5v After 2min - Battery Voltage 12.49v System has been installed about 2 years now. Battery voltage ...   Saturday Jul 24th, 2010 06:09 am

I have a SEM02 (PC01-008C) vF4.177 I can see JP1 12VDC Power Supply Terminal but I can not find a Battery Connection? Q1 If Comfort ...   Saturday Jul 24th, 2010 05:42 am

The slave can be powered also by the main panel if the via J10 connection, as it is in system. I assume this is OK? If ...   Saturday Jul 24th, 2010 04:04 am

I do not have a battery connected to the slave but I have one connected to the main panel. Because the slave is in the ...   Saturday Jul 24th, 2010 03:17 am

Hi Support, At 12:01 most days I receive a "Low Battery # Slave 1" Warning at 12:02 it restores. Is this an issue in my configuration or ...   Saturday Jul 24th, 2010 02:44 am