KP06/KP06A/KP04A Keypads > New Keypad Design Poll (46 replies - 86220 views)
B - black surround may not show dirt as easily as silver.
But I suggest the more prominently marked buttons of A, easier to see for ... Monday May 9th, 2011 02:45 am Vocabulary Issues > Vocabulary differs... (3 replies - 8844 views)
This system has been upgraded several times. As far as I can see, the UCM01 was used for the old RS232 interface, now unused as ... Monday May 2nd, 2011 09:57 am Vocabulary Issues > Vocabulary differs... (3 replies - 8844 views)
for as long as I can remember, every time I write PC-> Comfort, I get he message "This configuration's vocabulary differs from that currently defined ... Sunday May 1st, 2011 06:41 pm UCM Problems > Failed to connect to UCM/Ethernet (2 replies - 4967 views)
Thanks for the reply. What caused the problem was that on upgrade the Port was set to 1001; when I set it back to 10001 ... Sunday May 1st, 2011 01:48 pm UCM Problems > Failed to connect to UCM/Ethernet (2 replies - 4967 views)
I have updated Comfigurator from 3.1.9.0 to 3.2.8.0 and cannot get the PC to connect. I can ping the Comfort Ultra II, but not connect. ... Sunday May 1st, 2011 03:40 am Door Station Problems > Doorphone delay dialling PABX extensions (6 replies - 14652 views)
We are now been able to view the behaviour of Comfort on our PABX (Splicecom Maximiser).
Comfort immediately picks up the line, waits about 8 seconds, hangs ... Monday Jun 14th, 2010 03:32 am Door Station Problems > Doorphone delay dialling PABX extensions (6 replies - 14652 views)
I've tried that already. Wait for Dial Tone & Ignore Line Cut are unticked. If the Ringer module were still attached but unused, could that ... Monday Nov 24th, 2008 01:34 am Door Station Problems > Doorphone delay dialling PABX extensions (6 replies - 14652 views)
Problem:
It takes 5 to 6 seconds after the doorphone is pushed for the phones to ring. Visitors get impatient!
(Comfort 2 Ult v 5.121, Comfigurator v2.2.3)
Comfort ... Monday Nov 24th, 2008 12:43 am |