Comfort  Automation/ Security System Forums Home
Home Search search Menu menu Not logged in - Login | Register
Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > CM9001 fails to start up/ constantly resets

CM9001 fails to start up/ constantly resets
 Moderated by: admin
 New Topic   Reply   Printer Friendly 
 Rate Topic 
AuthorPost
 Posted: Wednesday Aug 10th, 2022 09:01 am
   PM  Quote  Reply 
1st Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5493
Status: 
Offline

  back to top

We have found a problem on some CM9001 systems with the J3 10 way connector for ETH03 or Wifi01 submodules. The symptom is Comfort fals to start up, and resets itself every 20 seconds.   The problem may be seen on some systems if there is NO plug in wifi01 or ETH03 submodule.   

The wporkaround is simply to plug in one of the EOL  resistors 2.2K or 4.7K between Pin 1 and Pin 7 as shown in the photo below. If the EOL resistors are not availabkle, any resistor fromn 1K to 10 Mohm can be used. he value is not important.

Please switch off the CM9001 system before doing this resistor insertion. If you need to use a wifi or ETH03 plug in in future, you can remove the resistor

It is recommended that the resistor be inserted even if there are no signs of the problem, to prevent it occuring in future



Attachment: CM9001 Resistor.jpg (Downloaded 16 times)

Last edited on Wednesday Aug 10th, 2022 11:24 am by slychiu



 Current time is 03:38 pm
Comfort Automation/ Security System Forums > Support > Problems & Troubleshooting > CM9001 fails to start up/ constantly resets
Top




UltraBB 1.172 Copyright © 2007-2014 Data 1 Systems