Comfort Automation/ Security System Forums > Support > Questions on Installation and Connection > Low level audio output instead of speaker level for alarm |
Moderated by: slychiu |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
freak69 Member
|
Hi, Just checking, is there any way I can tap off a low level audio output from the PCB? The current audio output for alarms is amplified and ideally I'd like to tap off an RCA level feed that I can mix with others before piping to a set of ceiling speakers. (Ideally I'd like to avoid a conversion high level to low level and tap off the main board)Same question from a slave board which happens to be nearer... Thanks! |
|||||||||
slychiu Administrator
|
If you mean the Siren Output, no, this is a square wave signal and there is no low levekl audio output However you can use the AUD01 audio output submodule which plugs ito a UCM/USB or UCM/ETH03 This has a phone jack which you can connect to an amplifier and has a cvolume adjustmentThe output from the AUD01 will be keypad speaker output, ie you will hear the keypad siren sounds and announcements lie a normal speakersee manual attached Attachment: AUD01man.pdf (Downloaded 7 times) |