Comfort Automation/ Security System Forums Home
Home Search search Menu menu Not logged in - Login | Register
Comfort Automation/ Security System Forums > Support > Questions on Installation and Connection > Low level audio output instead of speaker level for alarm

Low level audio output instead of speaker level for alarm
 Moderated by: slychiu
 New Topic   Reply   Printer Friendly 
 Rate Topic 
AuthorPost
 Posted: Thursday Aug 27th, 2020 07:31 pm
   PM  Quote  Reply 
1st Post
freak69
Member
 

Joined: Sunday Aug 9th, 2009
Location: United Kingdom
Posts: 28
Status: 
Offline

  back to top

Hi,
Just checking, is there any way I can tap off a low level audio output from the PCB? The current audio output for alarms is amplified and ideally I'd like to tap off an RCA level feed that I can mix with others before piping to a set of ceiling speakers. (Ideally I'd like to avoid a conversion high level to low level and tap off the main board)Same question from a slave board which happens to be nearer... 
Thanks! 


 Posted: Saturday Aug 29th, 2020 05:50 am
   PM  Quote  Reply 
2nd Post
slychiu
Administrator


Joined: Saturday Apr 29th, 2006
Location: Singapore
Posts: 5495
Status: 
Offline

  back to top

If you mean the Siren Output, no, this is a square wave signal and there is no  low levekl audio output
However you can use the AUD01 audio output submodule which plugs ito a UCM/USB or UCM/ETH03  This has a phone jack which you can connect to an amplifier and has a cvolume adjustmentThe output from the AUD01 will be keypad speaker output, ie you will hear the keypad siren sounds and announcements lie a normal speakersee manual attached


Attachment: AUD01man.pdf (Downloaded 7 times)


 Current time is 08:10 am
Comfort Automation/ Security System Forums > Support > Questions on Installation and Connection > Low level audio output instead of speaker level for alarm
 Top

UltraBB 1.172 Copyright © 2007-2014 Data 1 Systems