Comfort Automation/ Security System Forums > Products > KT03 Touchscreen Keypad (OBSOLETE) > KT03 - upgrade failed |
Moderated by: admin |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
Home Comfort Distributors
|
I've just been upgrading KT03 they take best part of 1/2hr when over the bus rather than USB direct ! Unfortunately the laptop im using went to sleep during the firmware upgrade and now the KT03 is dead - Can I still upload via the USB on the front? |
|||||||||
slychiu Administrator
|
When an upgrade fails for any reason, always do the upgrade again using the same method. In your case I assume by UCM. Doing by USB after it fails will not work, unless it was done by USB and failed A faster way is to use the UCM Programmi9ng Cable. Use a UCM and connect the firmware programming cable to KT03 This is much faster see http://www.comfortforums.com/forum4/1782.html |