slychiu
Administrator
Joined: | Saturday Apr 29th, 2006 |
Location: | Singapore |
Posts: | 5493 |
Status: |
Offline
|
back to top
|
I am glad you figured it out
My hypothesis is that when Comfort is scanning it hangs if it doesn't find a node.
That is not correct. UCM/Zwave will attempt to contact all nodes, but if any node does not reply, it will give up after a while. When the number of nodes is very large that may take a long time. So all nodes should be on line when doing a learn. There may be difefrent alternative network routes thatn are used to attempt to contact the nodes
Zwave is a complex system especialy for 3rd party secondary controllers. because it depends a lot on how the primary controller mages the network.
Could you send the module by post please
Cytech Technology Pte Ltd55 Ubi avenue 1 #07-04Singapore 408935
Ther module that we use has been obsoleted so we will not be sellong Zwave for much longer
|