| Posted: Sunday Jan 13th, 2019 07:27 pm |
|
1st Post |
Home
Comfort Installers
| Joined: | Wednesday Jul 12th, 2006 |
| Location: | United Kingdom |
| Posts: | 788 |
| Status: |
Offline
|
back to top
|
We have a new Comfort CPU 9000 - I note the following updates:
- The 8 outputs are removed from the main pcb and are on a daughter board. Would it not have made more sense to utilise an 'output' UCM in this way it may have been possible to remotely connect or mount the utput board !
- EOL jumpers are now revoved and appear to work well in software. YES WORKS WELL.
- Tamper is now a three pin fixed to pcb - this is helpful for joining commons BUT its a different type of connector that sticks out of the side of the pcb - will this not cause problems in packaging !
- X10 removed - yep about time its totally redundent you cannot buy the X10 DIN modules now even Insteon replacements are not available.
Is there anything else we should know about!
|
| Posted: Wednesday Jan 16th, 2019 04:10 pm |
|
2nd Post |
Home
Comfort Installers
| Joined: | Wednesday Jul 12th, 2006 |
| Location: | United Kingdom |
| Posts: | 788 |
| Status: |
Offline
|
back to top
|
I note that there is a new power supply
It appears to be a 15V DC (as opposed to the old 15V AC).
Presumably this is all ok with Comfort and has been soak tested etc.
|
| Posted: Thursday Jan 17th, 2019 04:25 am |
|
3rd Post |
slychiu
Administrator
| Joined: | Saturday Apr 29th, 2006 |
| Location: | Singapore |
| Posts: | 5716 |
| Status: |
Offline
|
back to top
|
Can you send a photo of the new board and power supply, to make sure that you have the correct set?
|
|
