The Vibration Analyser Response works as below;
Timer 8 is for timing and counter 7 for counting
If at least 2 counts are detected within 30 seconds, the alarm is triggered
you can change the timer setting of 30 seconds and the count of 2 as you need
If Timer Timer08 = 0 Then
Do NullResponse After 30 Seconds Using Timer08
Set Counter007 = 0
End If
Increment Counter007
If Counter Counter007 >= 2 Then
Stop Timer Timer08
Else
Skip Alarm
End If
At each zone trigger, the timer 8 is started and count is reset if timer 8 was not running
The counter is incremented. If the value < 2 the a;arm is skipped
If the value is >=2 the timer is stopped and the alarm is not skipped, ie alarm is activated
To add the condition if security is armed then activate the analyser;
If SecurityMode <> SecurityOff
If Timer Timer08 = 0 Then
Do NullResponse After 30 Seconds Using Timer08
Set Counter007 = 0
End If
Increment Counter007
If Counter Counter007 >= 2 Then
Stop Timer Timer08
Else
Skip Alarm
End If
End if
Last edited on Wednesday Aug 8th, 2018 11:52 am by slychiu
|