Comfort Automation/ Security System Forums > Support > Comfort Installation and Programming Guide > Comfort Installation Instructions > RS485 over Ethernet |
Moderated by: admin |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
LeeBurley UCM Pi Users
|
Hi,I have a Comfort system fully installed and working really well for a number of years. I need to add another keypad to the system but cant get a direct RS485 cable to the location. I do have IP network connectivity so I have bought a pair of RS485 to IP transceivers. Can someone let me know the RS485 settings in Comfort for Baud Rate, Parity etc so that I can "tunnel" the RS485 over Ethernet? Thanks in advance! |
|||||||||
slychiu Administrator
|
The Rs485 parameters are
|
|||||||||
LeeBurley UCM Pi Users
|
I am trying with another pair of rs485 devices which apparently support transparent tunnelling. On the comfort bus, is it half duplex? I think it must be due to the single pair of A and B but I could do with it being confirmed Thanks! |
|||||||||
slychiu Administrator
|
The communications is 1/2 duplex |