Posted: Tuesday Jun 20th, 2017 01:19 pm |
|
1st Post |
wexfordman
UCM Pi Users
Joined: | Monday Jan 1st, 2007 |
Location: | Cork, Ireland |
Posts: | 546 |
Status: |
Offline
|
back to top
|
Hi,
I have 4 scs switches, but two of them are no longer used so I need to remove them from my configurataion. I go to modules and settings, delete the removed ones, and then do a selective upload to update modules and setting.
However, once I do this, and then do a scan for all modules, comfort still detects 4 scs switches, even though two are removed, so it should only detect the remaining two ?
Would appreciate some quick advice on this, heading away tomorrow, so just want to get the comms failure cleared.
Regards,Eamon
|
Posted: Tuesday Jun 20th, 2017 02:15 pm |
|
2nd Post |
slychiu
Administrator
Joined: | Saturday Apr 29th, 2006 |
Location: | Singapore |
Posts: | 5493 |
Status: |
Offline
|
back to top
|
When you removed the SCS from the configuration did you also remove them from the system physically and change the ID setting so that the remianing ones are ID 1 and 2? If the SCS remain connected then Comfigurator will detect them and add them again
|
Posted: Tuesday Jun 20th, 2017 02:20 pm |
|
3rd Post |
wexfordman
UCM Pi Users
Joined: | Monday Jan 1st, 2007 |
Location: | Cork, Ireland |
Posts: | 546 |
Status: |
Offline
|
back to top
|
Hi, the scs are removed, but I didn't change the IDs of the remaining ones so that might be the problem
|
|