Comfort Automation/ Security System Forums > Products > Expansion Modules > Automatic Detection of LEM03 in Comfort |
Moderated by: admin |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
slychiu Administrator
|
From Comfort Firmware 7.117, Comfort will detect if the LEM03 is connected to it see http://www.comfortforums.com/forum79/4673.html The checkbox in Comfigurator > Configuration > Modules and Settings > LEM03 (24 Zone) can be ignored. After reading from Comfort this setting will show if LEM03 is connected or not, so it will be a Read Field. Writing into the LEM03 checkbox has no effect. The LEM03 state can only be seen after reading from Comfort Attachment: lem03Box.JPG (Downloaded 68 times) Last edited on Wednesday Dec 22nd, 2021 03:07 am by slychiu |
|||||||||
slychiu Administrator
|
SEM 7.118 firmware can also detect that a LEM03 is connected to it. This allows LEM03 to be used with Slaves Firmware 7.118 and above The LEM03 need not be connected only to the main Comfort controller. However LEM03 should only be connected to the LAST SEM. Connecting LEM03 to a lower ID SEM when there is a higher ID SEM will cause the zones on the LEM03 to conflict with the zones of the Higher numbered SEM See http://www.comfortforums.com/forum78/4562.html for SEM 7.118 firmware Last edited on Wednesday Dec 22nd, 2021 03:08 am by slychiu |