back to top

• Detect LEM or LEM03 connected for main Controller and slave
• Fixed Bug Scan for Modules via plug in ETH03 (Or USB for UCM/Logic) gave wrong modules if a UCM at ID 1 is not present.
  

Last edited on Wednesday Apr 12th, 2017 08:39 am by slychiu

  back to top

• Fixed BUG CM command counter value 0 to 9 did not work for Cytech App
  
• Control menu is authorised for engineer code
• Control menu  - control feedback for Counters dont change value incoming 1 to 255 (was used to support certian external ucms)
• Improved support for ETH03 plug in
  

  back to top

• The Counter Response is also activated when UCM/Logic  changes a Counter value. Eg by Responses/ Action codes or Control menu. Previously, Counter Response is avtivated only when the counter us changed by a UCM
• No of Responses number from 1024 to 512 affect ucm/log, knx/logic
  
• Removed  x10 responses not used affect knx/logic and ucm/logic
• For plug in eth03 for LGX, UCM/LOG, CM9001,  Sensor, Counter, Flag command will echo state eg C! Will  report CT
• enabled extended Sensors function
• Fix Bug counter report – if counter reponse changes another counter, the counter report for the changed counter has the same conterid as the original. So if KNX send counter, counter response change another counter and the counter is reported to knx, the counter id remaiins as KNX ucm id so the KNX ignores the new counter report
  

  back to top

• Fixed Bug Action 158 clear and set counter did not work, but toggle worked
• RIO Inputs and Outputs is supported