Moderated by: admin |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
slychiu Administrator
|
When writing to EEPROM, error: "UCM 2 is not a UCM/KNX2" or other type of external UCM which has been installed This is because the UCM used with Comfigurator is version 5.xxx It needs to be upgraded to the latest version 7 However for version 5 UCM firmware you need to have another UCM to upgrade this ucm using the UCM programming cable see http://www.comfortforums.com/forum4/1782.html When it has been upgraded to UCM firmware version 7, then this UCM can be used to upgrade Comfort ansd the UCM/KNX2 without the programming cable, just use Comfigurator If you do not have another UCM/USB or ETH03 perhaps you can borrow a UCM or ask your Comfort distributor to to the upgrade for you |