It's been a long time since i have setup a IR, I have copied the TX from the remote via the ethernet UCM, that was fine.
The issue is when IR is connected to an output I cannot find the files I need to associate with responces in "Responce Wizard"
Cannot remember how I done it before, Am I missing out on the programming as cannot find in manual for programing IR in "Responces"
when you learn an ir code it goes into the IR Library
You have to go to Configuration > IR Transmit Codes to select the IR code that you learned
The pulldown menu allows you to select the code that you learned
see the topic here
Thankyou for your responce, that was what I was doing!I have found that the IR will not work with my LEM01 and had to move it to No 16 Output in the main panel and it worked as it should.
Is their any known issues with using IR conected to Outputs beyond output 16?
Prior to putting it on Output 16 I tried to have connected to Output 21.
I noticed quite a few issues on my system where the IR was concerned and downgraded the use of comfigurator until it was working fine, Although admittedly I have not moved the IR back to the SEM as everything is working (if it isnt broke dont fix it rule) Not sure what was causing the issues as KT03 (the output signals)keypads were affected as well, I think there must have been a corrupt file somewhere along the line.