Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > CBus > EEPROM Missing/Faulty, UCM/Cbus |
Moderated by: admin |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
RahulPandey686 Member
|
I just updated my UCM/C-Bus module with the version 7.068, still showing - Not supported by firmware after update i am able to trigger the light which are connected with C-Bus but it showing in red letters that EEPROM Missing/Faulty My Comfort II ULTRA firmware is - Version 7.099 Attachment: Untitled.jpg (Downloaded 18 times) Last edited on Friday Jul 22nd, 2016 09:21 am by RahulPandey686 |
|||||||||
cleaner Member
|
Error is for ucm/USB or ucm/cbus? Did you upgrade ucm/cbus to 7.068 |
|||||||||
Ingo UCM Pi Users
|
Did you perhaps do this: http://www.comfortforums.com/forum85/3758.html |
|||||||||
slychiu Administrator
|
you upgraded the UCM/CBUS1 to UCM/CBUS2 UCM/CBUs1 does not have an EEPROM in U2 UCM/CBus2 requires an EEPROM in U2 The old Cbus SIM Module may also not be compatible with UCM/CBus see the 2nd topoc here http://www.comfortforums.com/forum11/3755.html regarding upgrading UCM/Cbus1 This shows the old SIM Module which is not compatible You need a new SIM Module and a U2 EEPROM 24C256 Take a photo of the UCM/CBus that you have Last edited on Friday Jul 22nd, 2016 06:05 am by slychiu |
|||||||||
RahulPandey686 Member
|
yeah thats UCM/C-BUS, I Wrote UCM/USB by mistake |
|||||||||
RahulPandey686 Member
|
yes i upgraded it to 7.068 Attachment: WP_20160722_10_37_55_Pro.jpg (Downloaded 15 times) |
|||||||||
RahulPandey686 Member
|
One more thing I also wanted to know in red letters it is written LineCut, Controller whats that mean? |
|||||||||
slychiu Administrator
|
The U2 socket seems to be empty ie no EEPROM as UCM/CBUS1 comes without the EEPROM You need to buy the 24C256 EEPROM, send an email to support@cytech.biz Otherwise you have to revert to the old Cbus1 firmware |
|||||||||
slychiu Administrator
|
RahulPandey686 wrote: One more thing I also wanted to know Line Cut means there is no telephone line connected to disable this message go to Securuty > Configuration flags, check "Ignore Line Cut"and do write to Comfort |