Comfort Automation/ Security System Forums > Third Party (interfacing to Comfort) > Zwave > Fibaro Smoke Sensor FGSS-001 |
Moderated by: slychiu |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
MDKKEN Member
|
Hi, I have the wired version of Fibaro Smoke Sensor FGSS-001 that is wired to comfort. This device supports Multilevel Sensor V1. I thought "sensor" would be available in register type drop down. In mine I only have flag and counter. I have latest firmware for ZWave and Comfort. Also latest version of configurator 3.11.1.0. Am I mistaken? I use VERA Edge as the primary controller. |
|||||||||
yuanchang Member
|
Hi MDKKEN, There are two solutions for this Fibaro Smoke Sensor FGSS-001's usage: First solution is to include this device into Z-wave network and use the UCM/Zwave learn from the primary controller. After that, map the device with any counter in comfigurator. Under corresponding counter response, program alarm trigger if the counter change to a certain value. Second solution is to connect the smoke sensor to any input of comfort directly and set the corresponding zone type as "Fire NC". |