Posted: Thursday Oct 1st, 2015 05:10 pm |
|
1st Post |
slychiu
Administrator
Joined: | Saturday Apr 29th, 2006 |
Location: | Singapore |
Posts: | 5493 |
Status: |
Offline
|
back to top
|
Changes from 7.078
Known Bugs- changing sensor values does not work. eg s!nnvv set sensor register does not work. Other ucms which change the sensor value also do not work
- If UCM IS #1 is not installed, if there is a Line Cut at Reset, it will cause the system to reset continuously - This firmware should not be used, it has been removed.
Bugs Fixed
- FIX BUG - if Disable Line Cut box is not checked and Misc alarm Line Cut Alarm = 0, 1 alert zone will cause intruder alarm.
- Fix BUG Logic engine slider cannot work send CMGGCCxx problem found by Seah ITE
- Fix Bug from 27/12/14 in alarm state, tunred on broadcast for keypads and this remains enabled eeven after disarm
- Fixed bug from 7.077. v! did not work unless full vocab transfer is done. sentence upgrade alone failed
- Fixed Bug for Action 155 - Send Custom SMS message # parameter inst of phone # for event log. added another event for custom message #
- Fixed bug when event log goes to 1st or last event, it did not announce the event menu, it used to go back to announce the same event
- Fixed bug gsm id was always 0 for a? Reply
Event Log- Added event type for Send SMS Custom message # for action 155 for gsm4. Event will announce number and "new message for"
- Event Log announcements start from last event and play backwards in time. But Read event log in Comfigurator still is from 1st to last.
- Fixed bug when event log goes to 1st or last event, it did not announce the event menu, it used to go back to announce the same event
- Event log when press keys 5,6,7,8 do not announce "wrong code" immediately announce the event menu
- Alarm history go to last event not at alarm history pointer, now the same as event log.
- Event log events battery warning, Phone Line trouble, system reset , Voice Fail etc all will have parameter 1 instead of a random number
UCM Commands- AMFF will not be reported when the zone alarm has no Nondetector alarm eg Alert/Perimeter
- Implement reply to reminder query RM
- Allow module scanning for ID7 (Sensor) and 8 (HIO)
- If Nondetector alarm for Phone trouble = 0, AM04 (Phone trouble Non detector alarm) will not be reported
New Features- Duress code only need to enter 1 time, instead of 2 times, in order to avoid problems
- Action 86 Check Timer Action return 0 if not running, and returns the Remaining Timer value in seconds if timer is running. eg DA5601 (Do action 86 Check Timer 01). Reply RA8001 means Timer remaining time is 128 +256 = 384 seconds. This allows checking of timer to be implemented in Comfigurator.
- Implemented Execute Time Program Response command TPnn02 (nn = time program number in hex). This allows a command to execute the Response for the Time Program directly
- If a zone changed to Off without being previously ON or Trouble state, then Off Response is not activated (applicable for rare instances)
Last edited on Wednesday Oct 28th, 2015 09:25 am by
|
Posted: Wednesday Oct 28th, 2015 09:25 am |
|
2nd Post |
tech07
Administrator
Joined: | Thursday Jan 29th, 2009 |
Location: | Singapore |
Posts: | 106 |
Status: |
Offline
|
back to top
|
Bug in Firmware 7.083
If UCM IS #1 is not installed, if there is a Line Cut at Reset, it will cause the system to reset continuously - This firmware should not be used, it has been removed.
|
|