Moderated by: admin | Topic closed |
Author | Post | |||||||||
---|---|---|---|---|---|---|---|---|---|---|
slychiu Administrator
|
The Output Category contains all the actions involving Outputs Pulse Output Activate Siren Activate one of the 20 Siren Types. Select a Siren type to activate All Outputs off Turn off all outputs on Comfort, Slaves and Local Expansion Modules Bell Output Switch the Bell (Siren) Output On or Off Blinds Operation Select the Blind # (1 to 8), Operation Stop, Up or Down This refers to the Blinds Function in Functions Get Output State Get the value of the selected Output number. The value is 0 for off, or 1 for On. This value is used in the next Action "If Last Action Value" eg Get Output 1 If Last Action Value =0 Then .... Else .... Endif Infrared Command Any Infrared code in the IR Library (Configuration > Infrared Transmit Codes) can be selected to be transmitted to any Output in Comfort. An Infrared Transmitter (IRM01, IR01W, IR03W) must be connected to the selected Output and pointed at the Infrared Receiver. IRM01 is for longer distances (8 meters line of sight). IR01W is for short range 1 meter, IR03W is a stick-on IR emitter to be pasted over the IR receiver and comes with a visible RED led to show transmission Select the IR Code Name and Output Open Door Open the door or gate of the Door station with DM02 Select DM02 ID 1 to 3, and Pulse time in 10 ms units This response can be used in the Open Door or Open Gate Response in Events > Misc Events Set Output Select the Output #, and operation On, OFF, Toggle, Pulse 1 sec, Flash Flash Output will cause the output to alternate on and off at 2 second interval until an Output on or off command is sent to the same output Siren Off Turn off the active siren type Strobe Output Control the Strobe output. Select On or Off Switch Aux Supply On/off Control the S12V Output (Switched 12V) On or off. This is normally used to switch the S12V off to reset Smoke or heat detectors after they have been activated This can be in a Response assigned to the Security Off Response or Home Control Menu Toggle Output State Toggle the selected Output ie change the state of the output from off to on or vice versa. Last edited on Monday Sep 18th, 2017 03:33 pm by slychiu |